"IF YOU CAN DRAW IT, WE CAN MAKE IT!"TECHNOLOGY FOR THE 21ST CENTURY
The use of Hardware Accessories blade points
1. The welding cutting tool structure should have enough rigidity
Adequate rigidity is guaranteed with the maximum allowable dimensions and the use of higher strength steel grades and heat treatment.
2, carbide blades should be firmly fixed
The cemented carbide welding blade should have a sufficient degree of firmness. It is guaranteed by the sipe and welding quality. Therefore, the shape of the blade insert must be selected according to the shape of the blade and the geometry of the tool.
3, carefully check the arbor.
Before the blade is welded to the shank, the blade and shank must be inspected. The first step is to check that the blade support surface cannot be severely bent. The hard alloy welding surface must not have a severe carburized layer. Carbide should also be used. The dirt on the surface of the blade and the arbor insert groove is removed to ensure reliable welding
4, the rational choice of solder
In order to ensure the welding strength, suitable solder should be selected. During the welding process, good wettability and fluidity should be ensured, and air bubbles should be eliminated so that the welding and the alloy welding surface can be in full contact with each other, and there is no lack of welding phenomenon.
5, the correct choice of welding flux
Industrial borax is recommended. Dehydration should be performed in the drying furnace before use. It is then milled and sieved to remove mechanical debris.
6, use mesh compensation gasket
When welding high-titanium and low-cobalt fine-grain alloys and welding long and thin alloy inserts, in order to reduce the welding stress, it is recommended to use thin sheets with a thickness of 0.2 - 0.5 mm or mesh-compensated spacers with a mesh diameter of 2 - 3 mm for welding. .
7, the correct use of sharpening method
Because of the brittleness of carbide inserts, which are sensitive to crack formation, the tool should avoid overheating or quenching during the sharpening process. At the same time, it should also select the appropriate size of the grinding wheel and a reasonable grinding process to avoid sharp grinding cracks. Impact on tool life.
8, correctly install the tool
When installing the tool, the length of the tool head protruding from the tool holder should be as small as possible. Otherwise, the tool vibration may be easily caused, thereby damaging the alloy sheet.
9, correct regrinding, grinding tool
When the tool is used to achieve normal bluntness, it must be reground. After re-grinding, the tool must use Whetstone to grind the edge and corner of the tool tip, which will increase the service life and safety of the tool.